- Home
- Knowledge Base
Knowledge Base » SP01654
Important information about the ATC35L/ATC45L of the first months of production Suppose you intend to replace the bearings, piston, or levers in the ATC35L or ATC45L transfer cases made in the first months of production. In that case, you should keep the following fact in mind: a few months after the start of production of these transfer cases, the manufacturer changed the design—it switched from using thrust needle cages (No. 24 in the diagram) to needle bearing assemblies with washers.This also entailed changing the thickness of parts 22 (piston), 25 (moving lever), and 27 (fixed lever). That is, the indicated...
Transfer Cases
-
ATC13 : BMW
-
ATC300 : BMW 3 / 5
-
ATC350 : BMW X1 / 5 / 7
-
ATC35L : BMW 1/2/3/4/5/6/7/X1
-
ATC400 : BMW X3
-
ATC450 : BMW X3 /X5 /X6
-
ATC45L : BMW X3 / X4 / X5 / X6
-
ATC500 : BMW X5
-
ATC700 : BMW X5/X6
-
BW4430 : Audi Q7
-
CB40 (IRD) : Land Rover
-
DCD : Mercedes ML / GL
-
DCS : Mercedes ML / GL / R
-
HAA350+ : VAG
-
HAA450 : VAG
-
Hyundai ATC : Hyundai
-
ITC PLA : Land Rover
-
LX : Chrysler
-
M300+ : VW
-
Macan 95B : Porsche
-
Maserati ATC : Maserati
-
MFA RDM : Mercedes, Infiniti
-
NV125 : BMW X5
-
NV225 : Land Rover
-
NV235 : VAG
-
NV247 : Jeep
-
PL72 ATC : Porsche
-
PL72 T : VAG
-
PQ75+ : VW
-
RDM (312/319) : Fiat
-
SEC : Mercedes S/E/C-class
-
VAA350+ : VAG
-
VG150 : Mercedes
-
VG150 E : Mercedes
-
W61G : Nissan / Infiniti